How to fix Shimano E010 error?
When a shimano motor arrives looking like this and throwing E010 error codes there is only one way to fix this and it’s to do a full strip down and service. The E1 code clearly communicates that the system’s internal logic has encountered a condition it cannot safely ignore. It stands as an essential piece of diagnostic information indicating that the unit is not functioning as intended, and further investigation into the control module’s sensor data is warranted.
What is E010 error code on e-bike?
E010: A system error was detected. Power assistance is not provided during riding. Press the power button of the battery to turn it on again. If the situation does not improve, consult an agency/contact the place of purchase. Signs Your Ebike Controller is Failing Watch for these problems: Sudden loss of power: Sometimes the bike stops in the middle of the ride; it’s due to the motor cuts out even when the battery is full. Motor not starting: If you observe that your ebike is not starting at all, or it will start and then stop again.Check Electrical Connections If your battery holds a charge but the ebike is still not powering on, it may be that one of the electrical connections on the ebike is preventing it from powering on, and in order to isolate the problem you will need to check these connections one at a time.
How to fix W011 error Shimano?
Simply stop and restart the battery. Error code W011/W101: the maximum speed is not 25 km/h or the system cannot detect the speed of the Shimano bike. This occurs when the speed sensor and magnet are not aligned and need to be replaced. Error code W011/W101: the maximum speed is not 25 km/h or the system cannot detect the speed of the Shimano bike. This occurs when the speed sensor and magnet are not aligned and need to be replaced.